Table of Contents
Advertisement
4 Installation
No.
17.
Set the operating mode of the LOGO! logic module to
"RUN" by means of the symbol "Change LOGO!
operating mode".
Installation of the STEP 7 program
Table 4-4
No.
1.
Make sure all the components of STEP 7 and
WinCC have been installed.
2.
Start STEP 7 (TIA Portal).
3.
In STEP 7 (TIA-Portal), open the extracted file
23753479_Set23_RegSim_V23.ap12, see
Table 4-2, via the menu: "Project > open"
4.
Connect the PC via an Ethernet cable directly
or via a switch according to Figure 4-1 with the
S7-1200.
5.
Check the IP address of the S7-1200.
In this application, the IP address must be set
to 192.168.000.001 and the subnet mask to
255.255.255.000.
With the menu sequence "Online access >
network connection (PG/PC interface) >
update accessible devices", all the devices
that have been detected are displayed with
their IPO addresses.
If an IP address needs to be adjusted, you can
reset the S7-1200 to the factory settings as
follows: With the menu sequence
"CPUcommon ... or SIMATIC 1200station_1 >
Online & diagnostics > Functions > Reset to
factory settings > delete IP address"
Set23_RegSim
Entry ID: 23753479,
V2.3.S,
Action
Action
02/2014
Comments
Comments
See also Table 2-6:
In the "unpacked folder" 02_S7-1200
S7-1200
Configuration PC
Ethernet cable
network connection
18
Advertisement
Table of Contents
