Siemens LOGO! 0BA7 Manual page 17

4 Installation
No.
7. Set the IP address at the LOGO!:
Navigate, if necessary with the LOGO! button 
8.
to the menu item "Date/Time"
Use the button sequence ESC and  to navigate
9.
to "Stop".
10. Stop the program editing with the button sequence
OK ,  and OK.
Navigate to "Network" with the buttons  or .
11.
12.
Click the OK button three times to reach the menu
"Set IP address".
13. Skip this point if you do not wish to modify the
address.
Use the buttons  and  to navigate to the spot
you want to adjust. Set the value with the buttons 
and .
14.
Complete the setting with the OK button.
Leave the menu item by pressing the ESC button
twice. For starting the LOGO!, navigate to the menu
item Start with the buttons  or  and press the OK
button twice.
15. Connect the PC via an Ethernet cable directly or via
a switch according to Figure 4-1 with the LOGO! logic
module.
16. Load the program to the LOGO! logic module by
means of the "PC -> LOGO!" symbol .
LOGO!Soft Comfort checks the operating state of the
LOGO! and sets it to "STOP" when it is pressed and
then to "RUN".
Please note these LOGO!Soft Comfort dialog boxes.
Download is only possible only in LOGO! "STOP"
mode. The operating hours counter is reset at the
same time.
Set23_RegSim
Entry ID: 23753479, V2.3.S,
Action
02/2014
Comments
See also LOGO! Manual \3\
IP address
192.168.000.006
subnet mask
255.255.255.0
for this application
17