Table of Contents
Advertisement
MD SECITON
Note 1: About "R"
As this unit has only a few buttons, some operations require the use of remote commander (RM-S5EN/provided with unit: 1-476-086-21)
buttons. These operations are indicated as "R" in this manual.
Example:
MENU/NO "R"
Note 2: Incorrect operations may be performed if the MD test mode is not entered properly.
In this case, press the
1. PRECAUTIONS FOR USE OF TEST MODE
• As loading related operations will be performed regardless of the test mode operations being performed, be sure to check that the disc
is stopped before setting and removing it.
[MD ]
Z
Even if the
button is pressed while the disc is rotating during continuous playback, continuous recording, etc., the disc will not
stop rotating.
Therefore, it will be ejected while rotating.
[MD ]
Be sure to press the
Z
1-1. Recording laser emission mode and operating buttons
• Continuous recording mode (CREC 2MODE)
• Laser power check mode (LDPWR CHECK)
• Laser power adjustment mode (LDPWR ADJUST)
• Comparison with initial Iop value written in nonvolatile memory (Iop Compare)
• Write current Iop value in read nonvolatile memory using microprocessor (Iop NV Save)
• Traverse (MO) check (EF MO CHECK)
• Traverse (MO) adjustment (EF MO ADJUST)
[REC/REC IT]
• When pressing the
2. SETTING THE TEST MODE
The following are two methods of entering the test mode.
Procedure 1: 1. Press the
I/
1
[FUNCTION]
2. Press the
3. Press three buttons of
When the test mode is set, "[Check]" will be displayed. Pressing the
following three groups; ···Tt [Check] Tt [Service] Tt [Develop] Tt ···.
Procedure 2: 1. Press the
I/
1
[FUNCTION]
2. Press the
3. Press three buttons of
When the test mode is set, "TEMP CHECK" (C12) will be displayed. By setting the test mode using this method, only the
"Check" group of procedure1 can be executed.
Note: Do not use the test mode in the [Develop] group.
If used, the unit may not operate normally.
If the [Develop] group is set accidentally, press the MENU/NO "R" button immediately to exit the [Develop] group.
3. RELEASING THE TEST MODE
[REPEAT]
Press the
button to display "Initialize", then release the MD test mode.
4. BASIC OPERATIONS OF THE TEST MODE
All operations are performed using the
The functions of these buttons are as follows.
Function name
. m "R" , M > "R"
ENTER/YES "R" button
MENU/NO "R"
button
32
TEST MODE
[MENU/NO]
...Press the
button of the remote commander.
button to turn the power off, and retry to enter the MD test mode.
I/1
button after pressing the
MENU/NO "R"
button.
button to turn the power on.
button to set the MD function.
[PLAY MODE]
,
M >
button to turn the power on.
button to set the MD function.
[PLAY MODE]
. m
,
,
. m "R"
M > "R"
Function
buttons
Changes parameters and modes
Proceeds onto the next step. Finalizes input
Returns to previous step. Stops operations
SECTION 4
button and the rotation of disc is stopped.
[MD ]
, and
Z
simultaneously.
. m
, and
x
(MD) simultaneously.
,
ENTER/YES "R"
or
M >
button between the
"R"
"R"
and
.
MENU/NO "R"
Advertisement
Table of Contents
