Table of Contents
Advertisement
10. To power down RD60, hold the cycle stop button for 4 seconds. The button light will flash, then turn
off.
REMOVING THE DRILL BIT
WARNING!
DISCONNECT BATTERY
Do not install, change tool accessories, clean or perform maintenance on the tool while
the battery is connected to the tool. Remove the battery from the tool before performing
maintenance.
ACCIDENTAL ENGAGEMENT OF THE TOOL CAN CAUSE SERIOUS INJURY.
DRILL BITS ARE VERY SHARP
Do not touch without proper Personal Protective Equipment (PPE).
SERIOUS CUTS AND ABRASIONS CAN OCCUR
1.
Hold the cycle stop button for 4 seconds to power RD60 off.
2.
Remove battery from the battery compartment.
3.
Hold the two flat surfaces on the drill head with a wrench. Ensure it will not move.
4.
Twist the drill bit counter clockwise and remove it from the drill head.
5.
Tap on the exposed end of the ejector pin on the back of the drill bit. The slug will fall out.
6.
Reinstall the drill bit as shown in "Install Drill Bit" on page 22.
7.
Reinstall the battery as shown in "Insert the Battery" on page 24.
RECHARGE THE BATTERY
RD60 monitors the battery charge and will stop drilling when the battery needs to be recharged. When
this happens,
1.
Press the cycle stop button (red) to stop the drilling cycle.
2.
Press the cycle start button (green) to retract the drill.
3.
Open the battery compartment and pull out the battery.
4.
Charge the battery as shown in "Charge Battery" on page 19.
62211 | February 2022 | 27
Advertisement
Table of Contents
