Attach The Rail Clamp To The Rail; Connect And Pressurize The Coolant Canister - Stanley RD60 Operator's Manual

ATTACH THE RAIL CLAMP TO THE RAIL

1. Grab the carrying handle with your dominant hand.
2. Grab the clamp handle with your secondary hand.
3. Fit the rail clamp over the top of the rail.
4. Use the rail clamp adjustment knob to tighten the clamp around the rail.
NOTE
Ensure the clamp is tight and will not move during the drilling cycle.

CONNECT AND PRESSURIZE THE COOLANT CANISTER

NOTICE
Check coolant levels regularly when using the tool. Do not allow the coolant canister to
run out of coolant. Damage to the drill bit can occur.
1. Connect the coolant canister quick disconnect to the coolant inlet fitting on the tool.
RAIL CLAMP
ADJUSTMENT KNOB
62211 | February 2022 | 23