Install Drill Bit; Prepare Coolant Canister - Stanley RD60 Operator's Manual

Operation

INSTALL DRILL BIT

1. Remove drill bit from the drill bit storage container.
NOTE
Ensure the ejector pin is in place in the middle of the drill bit.
2. Place drill bit over the drill head.
3. Push the drill bit towards the drill head and twist the bit clockwise.
4. The drill bit will lock into place.
NOTE
To remove the drill bit, see "Removing the Drill Bit" on page 27.

PREPARE COOLANT CANISTER

NOTE
Use only coolant recommended by STANLEY.
1. Open the top of the coolant canister.
2. Pour the supplied coolant into the cannister using a 20:1 water-to-coolant ratio. Use only clean
water.
3. Put the lid back on the canister and shake to mix.
22