Replacing Hip99 Backup Batteries - iHome HiP99 Quick Start Manual

Hotel system for your iphone or ipod
Table of Contents

Advertisement

Listening to non-docking iPod or other portable audio devices
You can play an iPod without a docking port (or any other MP3 player/ portable audio device) through the HiP99 via the
Aux-in patch cord.
1. Plug the Aux-in patch cord into the headphone or line-out jack on your device.
2. Press
Button to turn HiP99 on.
Note: Please make sure no iPhone/iPod is docked in, otherwise you will play iPhone/iPod only.
3. Turn on and play your device.
4. Turn the Volume Wheel to adjust the system volume. You may need to adjust your device volume, too.
5. To turn off the unit, press the
Listening to Radio
Setting up Antenna
Extend wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the Radio
1. Press the Radio Button to turn the HiP99 on in FM radio mode.
2. Turn the Set Wheel to tune the radio to a desired FM station. The current radio frequency will show in the lower right
corner of the display.
3. Turn the Volume Wheel to adjust the system volume.
4. To turn off the unit, press the
5. To memorize the current station as a preset, press and hold one of the Preset Buttons (1-3) for 2 seconds. A beep will
confrim the station has been memorized. To access a preset station, just press the Preset Button once.
Dimmer Operation
During normal operation, press the Snooze/Dimmer Button to control the brightness of the LCD display.
USB Charger
The HiP99 has a USB 2.0 charging port located on the top of the unit which provides up to 500mA current to charge your
portbable device. Connect a USB cable (not included) from your device to the USB port to charge your device.
Note: Some devices may not charge using the USB port, even ones that can be charged by computer's USB port.
Please read your device's instruction book for details on charging requirements.
Install/Replace Backup Battery
The HiP99 uses a backup battery system to provide continuous alarm operation and clock
settings in the event of a power failure. If the Battery Low Icon located on the left of the
display is on, it is time to replace the backup batteries. Please make sure the AC adaptor
is connected, otherwise all settings may be lost during battery replacement.
Open the battery compartment cover located on the bottom of the unit. Insert 2 "AA"
batteries as indicated. Close the battery compartment.
We recommend the use of alkaline batteries for longer life.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.
Operating the HiP99
Button. Please remember to turn off your device, too.
Button (or press the Radio Button again).

Replacing HiP99 Backup Batteries

5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents