Advertisement
After installation has been completed, it is recommended that the Air Handler be checked against the following checklist.
1.
"Operational Procedure" for the system installation can be found in the outdoor unit installer guide and will be compatible with this Air
Handler.
2.
Make sure power is "OFF" at power disconnect switch.
3.
Check all field wiring for tight connections. See that grounding of unit is in accord with code.
4.
Make sure unit suspension (if used) is secure and that there are no tools or loose debris in, around or on top of the unit.
5.
Check all duct outlets; they must be open and unrestricted.
6.
Check drain lines and be sure all joints are tight.
7.
Make sure secondary drain pan is installed.
8.
Check power supply for correct requirements per unit nameplate.
9.
Check filters for proper size. Inform owner of proper procedure for removal and reinstallation.
10. Energize the system and carefully observe its operation; make any necessary adjustment.
11. Instruct owner, engineer (if possible) on proper operating procedure and leave Use and Care Manual with owner.
1.Be sure the disconnect switch is "OFF", and safety label (if any) is attached.
2.Check on field wiring for tight connections and grounding according to codes.
3.Check circuit protection for proper size per nameplate specifications.
4.Check control box panel — in place and secured.
NOTE: OPERATION OF HEATERS MUST BE CHECKED DURING THE OPERATION CHECK OF THE TOTAL SYSTEM.
Trane
6200 Troup Highway
Tyler, Texas 75707
www.americanstandard.com
For more information contact
your local dealer (distributor)
CHECKOUT PROCEDURES
SUPPLEMENTARY HEATERS CHECKOUT PROCEDURES,
IF USED DOES HEATER REQUIRE A SPECIAL CIRCUIT?
SEE "LIMITATIONS AND RECOMMENDATIONS"
Since the manufacturer has a policy of continuous product and product data improvement, it reserves the right
to change design and specifications without notice.
Advertisement
