Turn On The Geode; Reset The Geode - Juniper Geode GNS3 User Manual

Geode GNS3 Real-Time Sub-Meter GPS Receiver

3.2 Turn on the Geode

To turn on the Geode, press and release the power key
The green LED Activity Indicator turns on.

3.2.1 Reset the Geode

You can perform a soft or receiver reset for the Geode using
the power key by following the instructions below.
Soft Reset
A soft reset will set the Geode back to the default settings.
To perform a soft reset,
1. Press and hold the power key for 5 seconds.
2. When the LED Activity Indicator flashes slowly, release
the power key.
The Geode will perform a soft reset then turn off when the
reset is complete.
Receiver Reset
A receiver reset will set the Geode back to the factory
settings. To perform a receiver reset,
1. Press and hold the power key for 15 seconds.
2. When the LED Activity Indicator flashes quickly, release
the power key.
The Geode will perform a receiver reset then turn off when
the reset is complete.
22
Chapter 3 Getting Started
.