Industry Canada; Radio Frequency Safety - Juniper Geode GNS3 User Manual

Geode GNS3 Real-Time Sub-Meter GPS Receiver
In compliance with the FCC rules, 47 CFR 15.21, the user
must be notified that changes or modifications to the
device that are not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
Only approved accessories may be used with this
equipment. In general, all cables must be high quality,
shielded, correctly terminated, and normally restricted
to two meters in length. Wall chargers approved for
this product employ special provisions to avoid radio
interference and should not be altered or substituted. When
used with a 9-pin serial cable, a ferrite is required on the
cable near the end of the cable that connects to the Geode.
This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
Contains FCC ID: X3ZBTMOD8

12.2.2 Industry Canada

In compliance with Industry Canada rules, the following
statement must appear on the device or in the user
documentation:
This Class B digital apparatus complies with Canadian
ICES-003.
Contains IC ID: 8828A-MOD8

12.2.3 Radio Frequency Safety

This device operates in compliance with the FCC radio
frequency exposure limits for an uncontrolled environment.
Users must follow instructions provided in the user
documentation to satisfy compliance with FCC radio
frequency exposure requirements.
164
Appendix C Regulatory Information