Hardware Settings; Amp Control; Exp Hold; Pedal Calibration - Boss GX-100 Parameter Manual

MENU

HARDWARE SETTINGS

AMP CONTROL

Specifies the operation of the AMP CTL 1, 2 jacks.
Parameter
LATCH
PULSE
AMP CTL1
AMP CTL2
INVERT

EXP HOLD

Parameter Value
ON
The operational status of the EXP 1 PEDAL and EXP 2
定義されていません。) is not carried over when memories are switched.
The operational status of the EXP 1 PEDAL and EXP 2 is carried over when memories are switched, if the
EXP1
FUNC (EXP1 PEDAL, EXP
HOLD
EXP2
previous memory.
HOLD For example, if EXP PEDAL FUNCTION is set to FOOT VOLUME in both memories (the one before and the one
OFF
after the change), the volume corresponding to the position (angle) the pedal is in at the time of the
memory change will be maintained after the memory change. On the other hand, if the memory being
changed to is set to WAH, the volume is in accordance with the value set within the memory, and you'll
obtain a wah effect that is in accordance with a value that reflects the current position (angle) of the pedal.

PEDAL CALIBRATION

You can readjust the expression pedal so that it will operate optimally.
Parameter Value
THRESHOLD 1–16

LCD BRIGHTNESS

Here you can adjust the brightness of the characters in the display.
Parameter
LCD BRIGHTNESS

AUTO OFF

The GX-100 can turn off its power automatically. The power will turn off automatically when 10 hours have passed since you last
played or operated the unit. The display will show a message approximately 15 minutes before the power turns off.
With the factory settings, this function is turned "ON" (power-off in 10 hours). If you want to have the power remain on all the time,
turn it "OFF".
* When the power is turned off, any settings you were editing will be lost. You must save settings that you want to keep.
Parameter Value
OFF The power will not turn off automatically.
AUTO OFF
ON The power will turn off automatically when 10 hours have passed since you last played or operated the unit.
118
Value
Latch operation
Send a pulse when changing memories.
2)(P.エラー! ブックマークが定義されていません。) setting is the same as the
Adjusts the sensitivity at which the EXP 1 SW will respond.
Value
1–10 Higher values increase the brightness.
Explanation
Explanation
FUNC (EXP1 PEDAL, EXP
Explanation
Explanation
Explanation
2)(P.エラー! ブックマークが