Prime Bass Flanger - Boss GX-100 Parameter Manual

PRIME BASS FLANGER

A Prime Flanger effect for bass guitar.
Parameter Value
ON/OFF OFF, ON
0–100, BPM ŀ–Ō
RATE
DEPTH 0–100
0–100
RESONANCE
MANUAL 0–100
WAVEFORM TRI, SINE
0, 15, 30, 45, 60, 75,
SEPARATION 90, 105, 120, 135, 150,
165, 180
OFF, 0–100, BPM ŀ–Ō This sets the cycle of the step function that changes the rate and depth. When it is set to a
STEP RATE
TURBO OFF, ON
LOW DAMP -100–0
HIGH DAMP -100–0
FLAT, 20.0 Hz–12.5
LOW CUT
kHz
20.0 Hz–12.5 kHz,
HIGH CUT
FLAT
EFFECT 0–100
LEVEL
DIRECT MIX 0–100
40–250
BPM
Chain
Turns this effect on/off.
Sets the rate of the flanging effect.
* When set to BPM, the value of each parameter will be set according to the value of
the "MASTER BPM" specified for each memory. This makes it easier to achieve effect
sound settings that match the tempo of the song.
* If, due to the tempo, the time is longer than the range of allowable settings, it is then
synchronized to a period either 1/2 or 1/4 of that time.
Determines the depth of the flanging effect.
Determines the amount of resonance (feedback). Increasing the value emphasizes the
effect, for a more unusual sound.
Adjusts the center frequency at which to apply the effect.
Selects the type of wave.
Adjusts the diffusion. The diffusion increases as the value increases.
higher value, the change will be finer. Set this to "0" when not using the Step function.
If this is "ON" a more intense effect is produced.
Adjusts the amount of feedback for the low-frequency region.
Adjusts the amount of feedback for the high-frequency region.
Sets the frequency at which the low cut filter begins to take effect. When "FLAT" is
selected, the low cut filter has no effect.
Sets the frequency at which the high cut filter begins to take effect. When "FLAT" is
selected, the high cut filter has no effect.
Adjusts the volume of the flanger.
Adjusts the volume of the direct sound.
Adjusts the BPM value for each memory.
* BPM (beats per minute) indicates the number of quarter note beats that occur each
minute.
* When you have an external MIDI device connected, the MASTER BPM synchronizes
to the external MIDI devices tempo, making it impossible to set the MASTER BPM. To
enable setting of the MASTER BPM, set "SYNC CLOCK" to "INTERNAL".
Palette
Explanation
EFFECTS
75