Reverb - Boss GX-100 Parameter Manual

EFFECTS

REVERB

This effect adds reverberation to the sound.
Parameter Value
ON/OFF OFF, ON
HALL S
HALL M
PLATE
TYPE
ROOM
STUDIO
TIME 0.1 s–10.0 s
EFFECT 0–100
LEVEL
DENSITY 1–10
PRE-DELAY 0ms–200ms
FLAT, 20.0
LOW CUT
Hz–800 Hz
630 Hz–12.5
HIGH CUT
kHz, FLAT
DIRECT 0–100
LEVEL
CARRYOVER OFF, ON
48
Chain
Turns this effect on/off.
Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.
Simulates the reverberation in a concert hall. Provides mild reverberations.
Simulates plate reverberation (a reverb unit that uses the vibration of a metallic plate). Provides a
metallic sound with a distinct upper range.
Simulates the reverberation in a small room. Provides warm reverberations.
Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in recording
and other applications. Rather than emphasizing the reverberation, this reverb is used to produce a
sense of openness and depth.
Adjusts the length (time) of reverberation.
Adjusts the volume of the reverb sound.
Adjusts the density of the reverb sound.
Adjusts the time until the reverb sound starts to output.
Sets the frequency at which the low cut filter begins to take effect. When "FLAT" is selected, the low
cut filter has no effect.
Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high
cut filter has no effect.
Adjusts the volume of the direct sound.
Sets whether to make the sound of the effect carry over or not after you turn it off.
Palette
Explanation