Reverb Plus - Boss GX-100 Parameter Manual

REVERB PLUS

A reverb that you can set in greater detail than the standard reverb effect.
Parameter Value
ON/OFF OFF, ON
HALL S
HALL M
PLATE
ROOM S
TYPE
ROOM L
AMBIENCE
SPRING
TIME 0.1 s–10.0 s
TONE -50–0–+50
EFFECT 0–100
LEVEL
DENSITY 1–10
PRE-DELAY 0ms–200ms
FLAT, 20.0 Hz–
LOW CUT
12.5 kHz
20.0 Hz–12.5
HIGH CUT
kHz, FLAT
LOW DAMP -50–0–+50
HIGH DAMP -50–0–+50
MOD RATE 0–100
MOD DEPTH 0–100
0–100
DUCK SENS
0–100
DUCK PRE
0–100
DUCK POST
DIRECT 0–100
LEVEL
CARRYOVER OFF, ON
Chain
Turns this effect on/off.
Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.
Simulates the reverberation in a concert hall. Provides mild reverberations.
Simulates plate reverberation (a reverb unit that uses the vibration of a metallic plate). Provides a
metallic sound with a distinct upper range.
Simulates the reverberation in a small room. Provides warm reverberations.
Simulates the reverberation of a room larger than ROOM S.
Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in
recording and other applications. Rather than emphasizing the reverberation, this reverb is used
to produce a sense of openness and depth.
This simulates the sound of a guitar amp's built-in spring reverb.
Adjusts the length (time) of reverberation.
Adjusts the tonal character of the reverb.
Adjusts the volume of the reverb sound.
Adjusts the density of the reverb sound.
Adjusts the time until the reverb sound starts to output.
Sets the frequency at which the low cut filter begins to take effect. When "FLAT" is selected, the
low cut filter has no effect.
Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the
high cut filter has no effect.
Adjusts the amount of attenuation for the low frequency region.
Adjusts the amount of attenuation for the high frequency region.
Adjusts the speed at which the reverb sound is modulated.
Adjusts the depth to which the reverb sound is modulated.
Adjusts the sensitivity by which the volume is automatically adjusted according to the input.
Increasing this value makes the response more sensitive at lower volumes.
When the input sound is loud, this automatically reduces the volume that is being "input" to the
reverb and delay. As this setting approaches 100, the output volume reduction is applied more
deeply.
When the input sound is loud, this automatically reduces the volume that is being "output" from
the reverb and delay. As this setting approaches 100, the output volume reduction is applied
more deeply.
Adjusts the volume of the direct sound.
Sets whether to make the sound of the effect carry over or not after you turn it off.
Palette
Explanation
EFFECTS
49