2.2 Software Configuration File
Some specialized hidden options and functionalities can only be modified via
the software configuration file Seunis.config. The default location of the con-
figuration file is
C:\Users\<USERNAME>\AppData\Roaming\Teledyne
2.3 Software Startup
To start the software, the device must be switched on, as the available mea-
surement modes are read out from the internal memory. Alternatively the
software can be started with the Teledyne Viewer Key.
2.4 Power Supply & USB Connection
To enable measurements, connect the USB port of the instrument to a com-
puter. Please follow the instructions given below:
•
If available plug the Mini-USB-B plug connector of the USB-cable into
the corresponding USB-jack connector of the device and the USB-A
plug into a USB-port of your computer.
•
Turn on the device by pressing the power button for more than 1 sec-
ond. After a few seconds, the button LED changes to red. The device
can be turned off by pressing the power button for more than 3 sec-
onds.
•
The 2-state red-green LED signals have the following meaning:
Green
blinking LED: Device switched off, battery charging active
Red
blinking LED:
Red
LED turned on:
•
The software will automatically probe your USB ports to communicate
with the device. You can check if this was successful in the status bar
on the bottom of the Main Window, which shows whether the device
is Connected or Not connected.
T3SP-Series Operator's Manual
Device switched on, battery charging active
Device switched on, battery charging finished
.
10
931776 RevE