Pegs Installation (If Equipped); Bell (If Equipped) - Huffy BMX Owner's Manual

Pegs Installation - Threaded (if equipped)
NOTES
• Front and rear pegs may be different sizes.
• The pegs are optional. You may choose not to install them on the axles. Pegs can be
installed on the front, rear or on one side.
• The same procedure is used to install pegs on both the front and rear axles. Front wheel
axle is shown.
Threaded pegs:
• No additional tools are necessary
to install the pegs.
A
• Put a peg
axle.
• Make sure the peg is fully seated
against the frame or fork. Tighten
the peg securely.
• Pegs will go over the axle nuts
WARNINGS:
• Do not ride beyond your capa-
bilities.
• Pegs should be installed by an adult.
• Check before each ride.
• Ensure there is no damage to frame, fork or wheels during install and use.
• Ensure chain is properly adjusted after install.
• Ensure wheels are properly aligned after install.
• If damaged, stop use and replace.
• Failure to obey these steps can allow the front wheel to loosen while riding. This can
cause injury to the rider or others.
Handlebar Bell (various models)
20
on each end of the
B
.
Installation:
1. Remove screws from Bell.
2. Position Bell on handlebar within easy reach,
with hands on the handlebar grips.
3. Install screws and tighten.
NOTE: Bell may attach with 1 or 2 screws.
B
A