Care And Cleaning; Changing The Temperature Scale; Troubleshooting - Braun ThermoScan IRT 3030 Manual

Care and cleaning

The probe tip (5) is the most delicate part of the thermometer .
It has to be clean and intact to ensure accurate readings .
If the thermometer is accidentally used without a disposable
Hygiene cap, clean the probe tip as follows:
Very gently wipe the surface with a cotton
swab or soft cloth moistened with alcohol . Do
not use cleaners other than alcohol on the
probe tip . Use of other cleaners could damage
the tip .
Once the alcohol has dried completely, a new disposable
Hygiene cap can be put on and a temperature measurement
taken . If the probe tip is damaged, please contact your
authorized local service center .
Use a soft, dry cloth to clean the thermometer display and
product exterior . Do not use abrasive cleaners . Never
submerge this thermometer in water or any other liquid .
Store the thermometer and disposable Hygiene caps in a dry
location free from dust and contamination and away from
direct sunlight .
Additional disposable Hygiene caps (LF40) are available at
most stores selling Braun ThermoScan .
Trouble-shooting
Situation
No disposable
Hygiene cap is
attached .
Measurement before
device stabilization .
Ambient
temperature is not
within the allowed
operating range
(10–40 °C or
50–104 °F) .
8
Solution
Attach new, clean, disposable
Hygiene cap .
Wait until all the icons stop
flashing .
Allow the thermometer to remain
for 30 minutes in a room where
the temperature is between
10 and 40 °C or 50 and 104 °F .
Temperature taken is
not within typical
human temperature
range (34–42 .2 °C or
93 .2–108 °F) .
System error .
Battery is low .
Battery is too low .
Device cannot be
powered on to the
ready state .
Do you have any further
questions?

Changing the temperature scale

Make sure the thermometer is turned off . Press
and hold down the <<start>> button . Keep
holding down the <<start>> button and after
about 3 seconds the display will start to cycle
between temperature scales (°C or °F) .
Release the start button when the desired scale
is shown . This will reset the thermometer to the
new temperature scale .
English
Make sure the probe tip and lens
are clean and a new, clean,
disposable Hygiene cap is
attached . Make sure the
thermometer is properly inserted .
Then, take a new temperature .
Reset the thermometer
by removing the battery and then
replacing it again, wait 1 minute,
then turn on again .
Please contact your authorized
Service Center (See Guarantee
Card) .
Insert new battery .
Insert new battery .
Please contact your authorized
Service Center (See Guarantee
Card) .
9