Pairing Your Ant+ Sensors; Heart Rate Monitor - Garmin Forerunner 910XT Owner's Manual

Pairing Your ANT+ Sensors

Before you can pair, you must put on
the heart rate monitor or install the
sensor. See the quick start manual or the
accessory instructions.
If your Forerunner does not show data
from the accessory, you may need to pair
the accessory to your Forerunner. Pairing
is the connecting of ANT+™ wireless
sensors, for example, connecting your foot
pod with a Forerunner. After you pair the
first time, your Forerunner automatically
recognizes your foot pod each time it is
activated.
• Make sure the ANT+ sensor is
compatible with your Forerunner.
• Bring the Forerunner within 3 m of the
ANT+ sensor.
• Stay 10 m away from other ANT+
sensors while pairing.
is off, select MODE > Settings >
• If
run Settings > Heart rate > ANT+
Hr > Yes > restart Scan.
is off, select MODE > Settings
• If
> run Settings > Foot Pod > Yes >
restart Scan.
22
• If is off, select MODE > Settings
> Bike Settings > bike name > ANT+
Spd/Cad > Yes > restart Scan.
• If is off, select MODE > Settings
> Bike Settings > bike name >
ANT+Power > Yes > restart Scan.
• If you still cannot pair the accessory,
replace the accessory battery (see
page 44 or accessory instructions).
When the accessory is paired, a message
appears, and the accessory icon
appears solid on the screen.

Heart rate Monitor

NOTE: The Forerunner cannot record
heart rate data while swimming.
Putting on the Heart rate Monitor
NOTE: If you do not have a heart rate
monitor, you can skip this task.
Wear the heart rate monitor directly on
your skin, just below your breastplate. It
should be snug enough to stay in place
during your run.
1
Connect the heart rate monitor module
to the strap.
➊
(page 5)
ANT+ Sensors