Camera Names; Primary Data Source Selection - Furuno NAVNET 3D MFD8/12/BB Installation Manual

3.3.3. Camera Names

You can assign names to each connected Analog and IP Camera. These names will be
used by the RotoKey and for the Video ID in the main interface.
The IP Camera names are Global and only need to be configured at the Master MFD.
However, the Analog cameras must be named at each MFD where they are connected.
Please refer to the Appendix "How to configure the AXIS IP Camera" for more
information.
Note: "PnP" refers to the Analog Connection (Picture in Picture). Four PnP are available
on the MFDBB and two on the MFD8/12.
Click on "Next" to continue the configuration

3.3.4. Primary Data Source selection

IMPORTANT!: As explained in section 3.2.3 NMEA, if you have NMEA0183 sensors
connected to the input ports of MFD(s) on the network, you first need to configure the
55