Furuno NAVNET 3D MFD8/12/BB Installation Manual page 50

IMPORTANT!: After configuring any NMEA0183 Input Port Sensors on the Master
MFD, you must REPEAT THIS PROCEDURE at any other Slave MFDs in the network
where you have connected NMEA0183 Input Sensors!! If this is not done, the sensors
will not be available for selection as a Primary System Data Source in the Global
Settings Tab.
Example: If you connect a sensor such as a PB100 which provides Wind information but
also Position, you will have to check "Position & SOG/COG" as well as "Wind"
When you connect a GP320B (FUSA P/N= BBWGPS) to NMEA Port 1, a "Page 2"
automatically appears in the lower right corner of the page. Click on this button to
configure advanced settings of the GP320B.
Name
POS.
When the receiving condition is unfavorable, the GPS fix may change,
Smoothing
even if the vessel is stopped. This change can be reduced by smoothing
Description
50