Setting Of Motion Sensor/Satellite Compass; Adj Motion Sensor Menu - Furuno CH-300 Installation Manual

3. ADJUSTMENT
3.6

Setting of Motion Sensor/Satellite Compass

When connecting the motion sensor, clinometer or satellite compass, enter
ship's roll and pitch angles as shown below. Note that the adjustment can be
done only when connected to the MOTION SENSOR port. For the satellite
compass, however, do not duplicate this adjustment; enter values at one location
only.
1. Press the MENU key to display the user menu.
2. Press to ► select SYS at the top of the menu display.
3. Press ▼ to select GO TO SYS.
4. Press ◄ to select YES.
5. Press ▼ to select ADJ MOTION SENSOR, and then press ► to display the

ADJ MOTION SENSOR menu.

ROLL ANGLE:
PITCH ANGLE: 0˚
: SELECT
*: For Clinometer BS-704, tilt angle is displayed. For Motion Sensor MS-100,
the readout is "0" (zero) when the ship is stopped, regardress of actual roll or pitch.
6. Press ▲ or ▼ to select ROLL ANGLE or PITCH ANGLE.
7. Press ◄ or ► to adjust (-10° to +10°).
8. For MS-100, use a clinometer or other similar measuring device to measure
ship's semi-permanent inclination angle. Take the polarity of the angle. For
example, if the stern is 3° down, set -3°.
ROLL ANGLE
PITCH ANGLE Stern up
For clinometer BS-704, adjust so that the indication shows "0" (zero).
9. Press the MENU key several times to close the menu.
3-8
** ADJ MOTION SENSOR **
0˚ ADJ: +5* ˚ (-10˚ - +10˚)
ADJ: +5* ˚ (-10˚ - +10˚)
: CHANGE MENU: END
Adj motion sensor menu
+ –
0
+
Starboard up
+ –
0
-
Starboard down
Stern down