Yamaha XRS900 Series Owner's Manual page 28

Instrument and control functions
Right
1
2
3
4
5
1. Stop/Run/Start switch "
2. Drive mode switch "MODE"
6
3. Hazard switch " "
7
Pass switch " "
Press this switch to flash the headlight.
8
TIP
When the dimmer switch is set to "
9
the passing switch has no effect.
10
Dimmer switch "
Set this switch to "
11
beam and to " " for the low beam.
12
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
1
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
2
turned to the center position.
3
Horn switch "
/ / "
Press this switch to sound the horn.
Traction control system switch
EAU12352
"TCS"
With the throttle closed, push this
switch down to change from TCS "1" to
"2". Push up to change from TCS "2" to
",
"1".
With the vehicle stopped, push this
switch up for two seconds to turn the
system off. Push down to turn the sys-
EAU12402
/ "
tem on.
" for the high
TIP

The current TCS setting is shown
in the TCS display (page 3-8).

See page 3-16 for an explanation
EAU12461
/ "
". To signal a left-hand
". When re-
EAU12501
"
EAU73391
3-13
of the traction control system and
the TCS settings.
Stop/Run/Start switch "
To crank the engine with the starter, set
this switch to " ", and then push the
switch down towards " ". See page
5-2 for starting instructions prior to
starting the engine.
Set this switch to " " to stop the engine
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU54212
/ / "
EAU12735
" posi-
ECA10062