Bosch DIVAR IP all-in-one 7000 3U Quick Installation Manual page 14

14 en | System overview
Hard drive carrier LEDs
The chassis supports hot-swappable SAS/SATA hard drives in hard drive carriers. Each hard
drive carrier has two LEDs on the front of the carrier: one activity LED and one status LED.
Note: For non-RAID configurations, some LED indications are not supported, for example hot
spare.
Activity LED
Status LED
Power supply LEDs
On the rear of the power supply module, an LED displays the status.
LED color
Green
Amber
2021.10 | V02 | DOC
LED Description
This LED indicates network activity on GLAN2 when flashing.
NIC2
This LED indicates network activity on GLAN1 when flashing.
NIC1
This LED indicates activity on the HDDs or peripheral drives when flashing.
HDD
This LED indicates that power is being supplied to the system's power supply
units.
This LED should normally be illuminated when the system is operating.
Power
LED color
Blue
Blue
Red
Red
Red
Red
Red
LED state
Solid On
Solid On
LED state
Solid On
Blinking
Solid On
Blinking at 1 Hz
Blinking with two
blinks and one stop
at 1 Hz
On for five seconds,
then off
Blinking at 4 Hz
Description
Power supply is on.
The power supply is plugged in and turned off
or
The system is off but in an abnormal state.
Quick installation guide
DIVAR IP all-in-one 7000 3U
Description
Hard drive is installed.
I/O activity.
Failed hard drive with RSTe
support.
Rebuild hard drive with RSTe
support.
Hot spare for hard drive with
RSTe support.
Power on for hard drive with
RSTe support.
Identify hard drive with RSTe
support.
Bosch Security Systems B.V.