Bosch DIVAR IP all-in-one 7000 3U Quick Installation Manual page 21

DIVAR IP all-in-one 7000 3U
Installing the chassis in a standard rack
To install the chassis in a standard rack:
1.
2.
3.
4.
5.
Installing the chassis in a Telco type rack
Notice!
i
Do not use a two post "Telco" type rack.
To install the chassis in a Telco type rack:
1.
2.
3.
4.
Bosch Security Systems B.V.
Extend the outer rails.
Align the inner rails of the chassis with the outer rails on the rack.
Slide the inner rails into the outer rails, keeping the pressure even on both sides.
Push the chassis completely into the rack and make sure that it clicks into the locked
position.
Optionally, use screws to secure the front of the chassis to the rack.
Determine how far the chassis will extend out the front of the rack.
Put larger chassis so that the weight between front and back is balanced.
If a bezel is included on the chassis, remove it.
Attach one L-shaped bracket to each side of the chassis front and one L-shaped bracket
to each side of the chassis rear.
Make sure that the brackets are positioned with just enough space to fit the width of the
Telco rack.
Slide the chassis into the rack and tighten the brackets to the rack.
Quick installation guide
Rack installation | en 21
2021.10 | V02 | DOC