Installing The Outer Rails To The Rack; Installing The Chassis In The Rack - Bosch DIVAR IP all-in-one 7000 3U Quick Installation Manual

20 en | Rack installation
5.4

Installing the outer rails to the rack

Outer rails attach to the rack and hold the chassis in place. The outer rails for the chassis
extend between 30 inches and 33 inches.
To install the outer rails to the rack:
1.
2.
3.
4.
Locking Tabs
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
system into place when installed and pushed fully into the rack, which is its normal position.
Secondly, these tabs also lock the system in place when fully extended from the rack. This
prevents the system from coming completely out of the rack when you pull it out for servicing.
5.5

Installing the chassis in the rack

You can install the chassis in a standard rack or in a Telco type rack.
Warning!
Stability hazard
!
Before sliding the unit out for servicing make sure that the rack stabilizing mechanism is in
place, or the rack is bolted to the floor. Failure to stabilize the rack can cause the rack to tip
over.
Warning!
Do not pick up the unit with the front handles. The handles are designed to pull the system
!
from a rack only.
Notice!
i
Mounting the chassis into the rack requires at least two people to support the chassis during
installation. Please follow safety recommendations printed on the rails.
Notice!
i
Always install chassis into racks from the bottom up.
2021.10 | V02 | DOC
1
2
Secure the back end of the outer rail to the rack, using the screws provided.
Press the button where the two outer rails are joined to retract the smaller outer rail.
Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the
front of the outer rail onto the rack.
Repeat steps 1-3 for the remaining outer rail.
3
Quick installation guide
DIVAR IP all-in-one 7000 3U
Bosch Security Systems B.V.