Depth Adjustment
NOTE: For this procedure, refer to FIGURE 13.3.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls are fully released and
protruding past the outer edge of the tube.
Mounting Hole
Quick Release
Pin
Part No 1143240
WARNING
Battery Frame
Three Depth
Adjustment Holes
Footboard
Assembly
FIGURE 13.3 Depth Adjustment
49
SECTION 13—FOOTBOARD ASSEMBLY
Bottom view
Quick Release
Pin
Outer Edge of
Tube
Pronto® M71™Base with SureStep®
Detent Balls