Assembly - Invacare Pronto M71 Owner's Operator And Maintenance Manual

Assembly

When reassembling the base frame be sure that the motor, battery and joystick leads
are positioned away from any of the three side frame attachment points
(FIGURE 16.3) and the four seat frame attachment points (FIGURE 16.3) - otherwise
pinched cables could result. It is recommended that the cables from the controller
are draped over the front of the shroud (FIGURE 16.2) and tuck the motor leads
(from each side frame) behind the rear spring in the side shroud (FIGURE 16.2).
NOTE: For this procedure, refer to FIGURE 16.2 and FIGURE 16.3.
Installing the Side Frame assemblies onto the Battery Tray
1. Using your right hand, grip the right side frame at the hand hold area (See FIGURE 2)
and slide close to the battery section.
2. Using your left hand, grip the handle on the battery section and rotate the battery
section to align the battery tray hook (Battery Tray Label #3) with the lower clevis pin
(Right Side Frame Label #3).
3. Continue sliding the right side frame towards the battery section and guide the hook
onto the front lower clevis pin.
4. Continue lifting the handle on the battery section and guide the rear upper clevis pin
(Right Side Frame Label #2) into the slot on the rear of the battery tray (Battery Tray
Label #2).
5. Push right side frame towards the battery section until an audible click is heard to
confirm that the front upper clevis pin (Right Side frame Label #1) is locked in place
(Battery Tray Label #1).
6. Repeat STEPS 1 to 5 for the opposite side frame.
Installing the Batteries
7. Insert front battery first with battery terminals towards the front of the wheelchair and
ensure front battery is sitting firmly in the bottom of the battery tray. Slide front
battery forward into position.
8. Insert rear battery with battery terminals towards the front of the wheelchair and
ensure battery is sitting in the bottom of the battery tray.
9. Connect the rear battery to the front battery (GREY connector).
10. Connect the front battery to the controller (BLACK connector on the standard M71).
Final Assembly
11. Connect the right motor lead to the right motor connector. Align the RED connectors
on both the lead and connector.
12. Connect the left motor lead to the left motor connector. Align the RED connectors on
both the lead and connector.
13. Install the seat. Refer to Removing/Installing the Seat Assembly on page 44.
14. Connect the joystick cable. Refer to Disconnecting/Connecting the Joysticks on
page 42.
Part No 1143240
CAUTION
69
SECTION 16—TRANSPORT
Pronto® M71™Base with SureStep®