Power Wheels ROCK AND ROLL 76950 Owner's Manual page 11

9
Press Here
• Insert two #10 x 3 / " screws through the slots in the
4
headlight and into the pegs in the handlebar.
• Press firmly on the front of the headlight and tighten
each screw with a Phillips screwdriver. Make sure there
is no gap between the headlight and the handlebar.
10
Microphone
Knobs
Key Assembly
• Snap the knobs and key assembly into the handlebar
console.
• Bend the end of the microphone cord so that it forms
a "T".
• Insert the end of the microphone cord through the small
hole in the handlebar console.
• Fit the tab on the back of the microphone into the slot in
the handlebar console.
Assembly
Microphone
Cord
T-End
Handlebar
Slot
Console
11
Handgrip
• Fit a handgrip onto each end of the handlebar.
Helpful Hint: If the handgrips are difficult to slide onto the
handlebar, moisten the handgrips with warm water before
fitting them onto the handlebar.
12
Button End
Handlebar
• Insert the connector end of the handlebar wire harness
into the rectangular opening in the handlebar.
• Feed the handlebar wire harness through the handlebar.
• Push firmly on the button end of the handlebar wire har-
ness to snap it into the rectangular opening.
11
Handlebar
Handgrip
Handlebar
Wire Harness
Connector
End
Rectangular
Opening