Setting Up The Laminator - Fellowes NEPTUNE 125 Instructions Manual

LAMINATOR CONTROLS
A On/off switch
B Standby button & LED
C Pouch selection buttons
(3, 4, 5, 7 Mil.)
D Reverse button & LED
E Carry handles
FEATURES & TIPS
'System-Check' function
When switched on, the machine performs a
'System-Check' function. The control panel lights
quickly flash in sequence to check their operation.
'Safe Start' function
When switched on, the machine has a default 'Safe
3 Mil
Start' function which starts to warm-up at the 3 Mil.
setting. You may select other temperature settings
as required.
'Reverse' function
To eject the laminating pouch during use, press and
hold down the reverse button until the pouch has
ejected from the machine.
'Power Save' function
If the machine is not active for 60 minutes, the
'Power Save' function will place the machine into
standby mode. To operate the machine, press the
'standby' button.

SETTING UP THE LAMINATOR

1.
Ensure the machine is on a stable surface. Check that
there is enough clear space behind the machine to
allow items to pass through freely.
2.
Connect the supplied power cord to the machine.
403843_2_NA_Neptune_EFS_v6.2.indd 5
F Pouch / document entry slot
G Entry support shelf
H Pouch / document exit
I Cooling system vents
• Always put the item to be laminated into the ap-
propriate sized pouch.
• This machine does not need a carrier to laminate.
• Always test laminate with a similar size and thick-
ness before final process.
• If required, trim excess material from around the
item after lamination and cooling.
• For best results, use Fellowes® brand laminating
pouches: Enhance 3 Mil, Capture 5 Mil, Protect 7
Mil.
• When working with different pouch thickness' (tem-
perature settings) it is recommended to start first
with the thinnest pouches.
3.
Plug the machine in to an easily accessible main socket.
5
12/08/2009 16:21:21