Troubleshooting; Storage And Cleaning - Fellowes NEPTUNE 125 Instructions Manual

TROUBLESHOOTING

Problem
No 'red' power on LED
Ready light does not come on after a
long period
Pouch does not completely seal the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination
STORAGE & CLEANING
Switch off the machine at the wall. Allow the machine to cool.
The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to polish the machine.
Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue
off the rollers.
For optimum performance, it is recommended that cleaning sheets (Fellowes #5320603 are used with the machine regularly.
403843_2_NA_Neptune_EFS_v6.2.indd 7
Possible cause
Machine is not switched on
Machine is in a hot or humid area
Item may be too thick to laminate
Temperature setting may be incorrect
Temperature setting may be incorrect
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on rollers
Solution
Switch on machine at rear next to plug
inlet and at the wall socket
Move the machine to a cooler and
dry area
Pass through the machine again
Check pouch thickness is correctly
selected and pass through again
Check pouch thickness is correctly
selected and pass through again
Select reverse button and pull out the
item by hand
Pass cleaning sheet (Fellowes
#5320603) through the machine to
test and clean rollers
12/08/2009 16:21:21
7