Setting Up The Laminator - Fellowes L125 A3 Instructions Manual

FEATURES & TIPS
'Release' function
To remove or re-align a pouch during
lamination, activate the release lever
located on the back of the machine. The
pouch can only be removed from the
entry slot when the lever is activated.
Auto
Auto Shut Off
After 30 minutes the machine will
Shut
automatically go in to Auto Shut Off
Off
mode. The Power LED will flash red for
5 minutes and then turn off. The ready
LED will turn off. To continue using the
machine press the ON/OFF switch. The
machine will reset itself.

SETTING UP THE LAMINATOR

1.
Ensure the machine is on a stable surface.
2.
Check there is enough clear space (min 50cm) behind
the machine to allow items to pass through freely.
HOW TO LAMINATE
4.
Switch the power on (located at the side of the
machine).
5.
The red 'Power on' lamp will light up. The machine is
now heating up.
6.
When the machine is ready, the green 'Ready' lamp
will remain on.
7.
Place the document into the open pouch. Ensure the
document is centred against the sealed edge. Use the
appropriate pouch size for the document.
NEED HELP?
Let our experts help you with a solution.
www.fellowes.com
Customer Service...
Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.
Consider registering your machine at www.fellowes.com/register to receive updates and additional information.
For best results, use Fellowes ® brand pouches:
80 - 125 micron.
This machine does not need a carrier to laminate.
It is a carrier-free mechanism.
Always put the item to be laminated into the ap-
propriate sized pouch.
Always test laminate with a similar size and thick-
ness before final process.
Prepare pouch and item for lamination. Place item
within pouch centred and touching the leading
sealed edge. Ensure the pouch is not too large for
the item.
If required, trim excess material from around the
item after lamination and cooling.
3.
Plug the machine into an easily accessible mains
socket.
8.
Ensure the pouch enters the machine sealed edge
first. Keep the pouch straight and central within the
slot, not on an angle. Use the entry markings as a
guide.
9.
Upon exit, the laminated pouch may be hot and soft.
To prevent jamming remove the pouch immediately.
Place pouch on to a flat surface to cool. Take care
when handling a hot pouch.
5