Troubleshooting Chart - FWE COLD-TEMP URS-10 Operating Instructions Manual

FWE
REFRIGERATED "COLD-TEMP" SERIES
TROUBLE-SHOOTING CHART
PROBLEM
Control panel will not light up.
Cabinet will not reach
desired temperature.
Display reads "dE9F"
Display reads "dE9C"
1. It is possible that the unit will self-initiate a defrost if excessive ice is on coil. NOTE:
If the coil is not defrosted, temperatures will rise and reduced performance will
be noticeable. During the defrost cycle or the "Off Cycle" of the compressor, the
evaporator coil will defrost. The condensation from the evaporator coil flows from the
top of the unit down a drain in the back to a condensate pan. Vapor escapes through
the back grill. The vapor can sometimes be visible and should be considered a normal
operating condition
2. If the temperature zone is too high and cabinet will not chill to desired temperature:
Dirt, lint, and/or dust are on the condenser (compressor) coil. Check condenser coil
and clean if necessary. See "Cleaning The Condenser" section on Page 8 for proper
cleaning instructions.
REMEDY
• Cabinet not plugged into outlet or check
breaker to power outlet.
• Plug cabinet into properly grounded
electrical outlet.
Press "ON" Button
•
• Clean the Condenser; See Page 8 for
Instructions
• Opening door unnecessarily. Keep door closed
and latched shut after loading. Set temperature
to Display to °Celsius or °Fahrenheit Scale:
You may change the digital thermometer scale
to either C or F as follows: While unit is OFF,
press and hold the Power Button
until "dE9F" to "dE9C". Repeat to
change scale again.
• Temperature is set to Fahrenheit scale
• Temperature is set to Celsius Scale
9