FWE ETC-HD Series Operating Instructions Manual

Enclosed transport cabinet with removable heat module

Advertisement

Quick Links

OPERATING
INSTRUCTIONS
REMOVABLE HEAT MODULE
ETC-HD Series
Enclosed Transport Cabinet with
Removable Heat Module

Advertisement

Table of Contents
loading

Summary of Contents for FWE ETC-HD Series

  • Page 1 OPERATING INSTRUCTIONS REMOVABLE HEAT MODULE ETC-HD Series Enclosed Transport Cabinet with Removable Heat Module...
  • Page 2 FWE ENCLOSED TRANSPORT CABINET ETC Cabinet with Removable Heat Module CONGRATULATIONS..and thank you for purchasing an FWE Enclosed Transport Cabinet with Removable Heat Module. Your unit has been designed and manufactured under rigid controls to assure you the most efficient service.
  • Page 3 FWE REMOVABLE HEAT MODULE Can be used with or without water. With removable water pan secured by strap that doubles as handle Heat Control Main Thermometer Cord Power Winding On/Off Brackets Switch...
  • Page 4: Installation And Care

    ELECTRICAL REQUIREMENTS AND GROUNDING FWE Removable Heat Module or models operate on 120 volt, 60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped with a three prong grounding cord plug for your protection against possible shock hazards.
  • Page 5 CLEANING Keep your cabinet clean by simply wiping the interior and exterior, as needed, with a damp cloth or sponge and a mild soapy solution. NEVER USE ABRASIVES, ACIDS, OR STRONG CLEANERS. Do not flood or allow electrical parts to become wet. The interior tray slide assemblies and humidifier pans are CAUTION removable for easy cleaning.
  • Page 6 GENERAL OPERATING INSTRUCTIONS HEATED HOLDING AND TRANSPORTING 1) PLUG UNIT INTO OUTLET, making sure that it is a properly grounded power receptacle. Press ON-OFF rocker switch to "ON" position. 2) FILL THE HUMIDIFIER PAN WITH HOT WATER (Optional). The water pan is removable for ease in cleaning and filling. Fill this pan with HOT water prior to heating the cabinet.
  • Page 7: Troubleshooting Chart

    * * NOTE: CALIBRATION IS EXCLUDED FROM FWE WARRANTY. Thermostats on all units are calibrated at the factory prior to shipping. Due to conditions in transit, beyond our control, occasionally units will need to be re-calibrated prior to use.
  • Page 8: Wiring Diagram

    FWE REMOVABLE HEAT MODULE WIRING DIAGRAM 120v 220v...
  • Page 9: Parts List

    PARTS LIST FWE PARTS DEPARTMENT: 815 459 7500 CASTERS PART NUMBER 5” rigid CSTR 5 R-2 5” swivel with brake CSTR 5 SB-2 HARDWARE Door hinge, edgemount (pair) HNG 214 Door latch, edgemount, non-locking LTH DR Door latch, edgemount, locking...
  • Page 10 FWE ETC CABINET WITH REMOVABLE HEAT MODULE SERVICE RECORD Model Number ______________________ Serial Number ______________________ Date of Purchase ____________________ Notes: ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________...
  • Page 11: Limited Two-Year Warranty

    FWE ETC CABINET WITH REMOVABLE HEAT MODULE LIMITED TWO YEAR WARRANTY FWE / Food Warming Equipment Company, Inc. (Seller) warrants to the original purchaser, subject to the exceptions and conditions below, that FWE manufactured equipment shall be free from defects in material or factory workmanship, under ordinary use for the purpose for which it is designed.
  • Page 12 Food Warming Equipment Company, Inc. P.O. Box 1001 Crystal Lake, IL 60039-1001 Manufacturing Facilities: 7900 S. Route 31 Crystal Lake, IL 60014 FWE Parts Department: FAX: 815 459 7500 815 459 7989 OpsManual_ETCHD Series © 2008 Food Warming Equipment Co., Inc.

Table of Contents