Related Manuals for FWE PST-32
Summary of Contents for FWE PST-32
- Page 1 https://appliancetechmanuals.com OPERATING INSTRUCTIONS TOP MOUNT HEATED HOLDING Heated Holding Food Warmers With Dial Face Controls or HDM Controls...
- Page 2 Shown with optional Lexan door CONGRATULATIONS..and thank you for purchasing an FWE Top Mount heated serving cabinet. Your unit has been designed and manufactured under rigid controls to assure you the most efficient service. It is a full time unit, and may be used continuously.
-
Page 3: Installation And Care
ELECTRICAL REQUIREMENTS AND GROUNDING FWE standard models operate on 110/120 volt, 60 Hz, 1 ph, A.C. (unless ordered otherwise), and are equipped with a three prong grounding cord plug for your protection against possible shock hazards. - Page 4 FWE TOP MOUNT MOBILE HEATED CABINETS CARE AND CONTROLS CLEANING Keep your cabinet clean by simply wiping the interior and exterior, as needed, with a damp cloth or sponge and a mild soapy solution. NEVER USE ABRASIVES, ACIDS, OR STRONG CLEANERS.
- Page 5 FWE TOP MOUNT MOBILE HEATED CABINETS SERVICE RECORD Model Number ______________________ Serial Number ______________________ Date of Purchase ______________________ Notes: ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________...
- Page 6 https://appliancetechmanuals.com GENERAL OPERATING INSTRUCTIONS PRE-HEAT CABINET BEFORE LOADING FOOD 1) PLUG CABINET INTO A PROPERLY GROUNDED POWER RECEPTACLE. Press ON/OFF switch to “ON” position. The red indicating light will come on and remain on until power switch is turned to “OFF”, or the unit is unplugged.
- Page 7 https://appliancetechmanuals.com GENERAL OPERATING INSTRUCTIONS PUT HOT FOOD INTO A HOT CABINET 5) TRANSPORTING HOT FOODS. Your cabinet is equipped with a positive transportation latch to assure safety during transportation. Before moving the cabinet, keep it plugged in and wait until the amber cycling light goes off.
-
Page 8: Parts List
PARTS LIST FWE PARTS DEPARTMENT: 815 459 7500 CASTERS PART NUMBER 5” rigid CSTR 5 R-2 5” swivel with brake CSTR 5 SB-2 HARDWARE Push handle, aluminum bar, 12.5” HDL 12.5 AL Push handle, aluminum bar, 21.5” HDL 21.5 AL Spacers for push handles SPCR125x.330... -
Page 9: Troubleshooting Chart
* * NOTE: CALIBRATION IS EXCLUDED FROM FWE WARRANTY. Thermostats on all units are calibrated at the factory prior to shipping. Due to conditions in transit, beyond our control, occasionally units will need to be re-calibrated prior to use. -
Page 10: Wiring Diagram
FWE TOP MOUNT MOBILE HEATED CABINETS WIRING DIAGRAM BLACK PILOT WHITE T-STAT LIGHT BLOWER MOTOR BLACK WHITE HEATER BLACK WHITE BLUE BLOWER MOTOR BLACK WHITE BLOWER ORANGE MOTOR BLACK POWER CORD... - Page 11 FWE TOP MOUNT MOBILE HEATED CABINETS LIMITED TWO YEAR WARRANTY FWE / Food Warming Equipment Company, Inc. (Seller) warrants to the original purchaser, subject to the exceptions and conditions below, that FWE manufactured equipment shall be free from defects in material or factory workmanship, under ordinary use for the purpose for which it is designed.
- Page 12 Food Warming Equipment Company, Inc. P.O. Box 1001 Crystal Lake, IL 60039-1001 Manufacturing Facilities: 7900 S. Route 31 Crystal Lake, IL 60014 FWE Parts Department: FAX: Errors subject to correction. All specifications subject to change without notice. 815 459 7500 815 459 7989 ©...