Extron electronics VGAUXGA Line Drivers With Audio Extender Series User Manual page 23

Do not tin the wires!
Extender WM is shown here wired for balanced
audio output; the circuit board configuration is the same
for the Extender WM AAP and the Extender D
b
RGB video output connectors — Attach coaxial cables from the
Extender to the display device via these female BNC connectors.
These BNCs are on pigtail wires secured to the Extender by tie
wrap.
c
Power connector — Connect a 9 VDC to 18 VDC power supply
+ or –
– or +
Do not tin the wires!
C
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to the
negative (-) contacts.
Power
9-18 VDC
to this 3.5 mm, 2-pole direct insertion
captive screw connector. Wire the
connector as shown here. Polarity is not
important.
For best results and to reduce the risk of short circuits,
trim just / " (5 mm) of the jacket from the wires. Do
3
16
not tin the wires.
Extender Series • Installation
NO Ground Here
Right Tip
Sleeve(s)
NO Ground Here
Left Tip
Audio
Unbalanced Output
Right Ring
Right Tip
Sleeve(s)
Left Ring
Left Tip
Balanced Output
Right Ring
Right Tip
Sleeve (s)
Left Ring
Left Tip
2-11