Jeep 2022 CHEROKEE Owner's Manual page 179

3rd = 1.8 mph (3 km/h)

4th = 2.5 mph (4 km/h)

5th = 3.1 mph (5 km/h)

6th = 3.7 mph (6 km/h)

7th = 4.3 mph (7 km/h)

8th = 5 mph (8 km/h)

9th = 5.6 mph (9 km/h) – If Equipped

REVERSE = .6 mph (1 km/h)

NEUTRAL = 1.2 mph (2 km/h)

PARK = SSC remains enabled but not active

NOTE:
During SSC the +/- shifter input is used for SSC

target speed selection but will not affect the
gear chosen by the transmission. While actively
controlling SSC the transmission will shift appro-
priately for the driver-selected set speed and
corresponding driving conditions.
SSC performance is influenced by the

Selec-Terrain mode. This difference may be
notable to the driver and may be perceived as a
varying level of aggressiveness.
Driver Override:
The driver may override SSC activation with throttle
or brake application at any time.
Deactivating SSC
SSC will be deactivated but remain available if any
of the following conditions occur:
Driver overrides SSC set speed with throttle or

brake application.
Vehicle speed exceeds 20 mph (32 km/h) but

remains below 40 mph (64 km/h).
Vehicle is shifted to PARK.

Disabling SSC
SSC will deactivate and be disabled if any of the
following conditions occur:
The driver pushes the SSC button.

The driveline is shifted out of 4WD Low.

The parking brake is applied.

The driver door opens.

The vehicle is driven greater than 20 mph

(32 km/h) for greater than 70 seconds.
The vehicle is driven greater than 40 mph

(64 km/h) (SSC exits immediately).
Feedback To The Driver:
The instrument cluster has an SSC icon and the
SSC button has an LED which offers feedback to
the driver about the state SSC is in.
The cluster icon and button lamp will illuminate

and remain on solid when SSC is enabled or
activated. This is the normal operating condition
for SSC.
The cluster icon and button lamp will flash for

several seconds then extinguish when the driver
pushes the SSC button but enable conditions
are not met.
The cluster icon and button lamp will flash for

several seconds then extinguish when SSC
disables due to excess speed.
The cluster icon and button lamp will flash then

extinguish when SSC deactivates due to over-
heated brakes.
WARNING!
SSC is only intended to assist the driver in con-
trolling vehicle speed when driving in off road
conditions. The driver must remain attentive to
the driving conditions and is responsible for
maintaining a safe vehicle speed.
SAFETY 177
6