Table of Contents
Advertisement
194
SAFETY
2. Grab the mini-latch plate and pull the seat belt
over the seat.
Shoulder Belt Routed Through The Seat Belt Guide Loop
3. Route the shoulder belt through the seat belt
guide loop on the top of the seatback near the
inboard side of the left head restraint.
Inserting Mini-Latch Plate Into Mini-Buckle
4. When the seat belt is long enough to fit, insert
the mini-latch plate into the mini-buckle until
you hear a "click."
Mini-Latch Plate Buckled
5. Sit back in seat. Slide the regular latch plate up
the webbing as far as necessary to allow the
seat belt to go around your lap.
6. When the seat belt is long enough to fit, insert
the latch plate into the buckle until you hear a
"click."
7. Position the lap belt so that it is snug and lies
low across your hips, below your abdomen. To
remove slack in the lap belt portion, pull up on
the shoulder belt. To loosen the lap belt if it is
too tight, pull on the lap belt. A snug seat belt
reduces the risk of sliding under the seat belt
in a collision.
8. Position the shoulder belt on your chest so that
it is comfortable and not resting on your neck.
The retractor will withdraw any slack in the
seat belt.
Rear Center Seat Belt Buckled
9. To release the seat belt, push the red button
on the buckle.
Advertisement
Table of Contents
