Tires; Tire Safety Information - Jeep 2022 CHEROKEE Owner's Manual

Replacing Exterior Bulbs
BACK-UP LAMP
See below steps to replace:
1. Open the liftgate.
2. Use a fiber stick or flat blade screw driver at
the top of the bulb access cover to pry the
lower trim panel from the liftgate.
3. Once the access panel is loose, pull it back
exposing the insulation.
4. Move insulation towards center of vehicle to
expose the back of liftgate lamp.
5. Twist the socket counterclockwise and remove
from lamp.
6. Pull the bulb to remove it from the socket.
7. Replace the bulb, reinstall the socket.
8. Move insulation back to original position.
9. Close the liftgate.

TIRES

T S I
IRE AFETY NFORMATION
Tire safety information will cover aspects of the
following information: Tire Markings, Tire
Identification Numbers, Tire Terminology and
Definitions, Tire Pressures, and Tire Loading.
Tire Markings
Tire Markings
1 — US DOT Safety Standards Code (TIN)
2 — Size Designation
3 — Service Description
4 — Maximum Load
5 — Maximum Pressure
6 — Treadwear, Traction and
Temperature Grades
SERVICING AND MAINTENANCE
NOTE:
P (Passenger) — Metric tire sizing is based on US

design standards. P-Metric tires have the letter
"P" molded into the sidewall preceding the size
designation. Example: P215/65R15 95H.
European — Metric tire sizing is based on Euro-

pean design standards. Tires designed to this
standard have the tire size molded into the side-
wall beginning with the section width. The letter
"P" is absent from this tire size designation.
Example: 215/65R15 96H.
LT (Light Truck) — Metric tire sizing is based on

US design standards. The size designation for
LT-Metric tires is the same as for P-Metric tires
except for the letters "LT" that are molded into
the sidewall preceding the size designation.
Example: LT235/85R16.
Temporary spare tires are designed for tempo-

rary emergency use only. Temporary high pres-
sure compact spare tires have the letter "T" or
"S" molded into the sidewall preceding the size
designation. Example: T145/80D18 103M.
High flotation tire sizing is based on US design

standards and it begins with the tire diameter
molded into the sidewall.
Example: 31x10.5 R15 LT.
279
8