Table of Contents
Advertisement
English
7. TROUBLESHOOTING
If a problem persists even after applying the remedies suggested below, contact an EIZO
dealer.
• No picture problems → See No.1 ~ No.2
• Imaging problems
• Other problems
• USB problems
Problem
1. No picture
• Indicator status: Off
• Indicator status: Green
• Indicator status: Orange
• Indicator status: Flashing orange
slowly
2.
One of the error messages shown
below remains on the screen for 40
second.
• The message appears when the signal
is out of input range.
(Example)
3. The screen is too bright or too dark.
26
7. TROUBLESHOOTING
→ See No.3 ~ No.6
→ See No.7 ~ No.10
→ See No.11 ~ No.12
Points to check and possible solutions
Check that the power cord is connected
correctly. If the problem persists, turn off the
monitor power for a few minutes, then turn it
back on and try again.
Check the <Brightness> setting.
Try pressing a key on the keyboard or clicking
the mouse (see p. 21).
Try turning the PC on.
Try touching the power switch (see p. 20).
These messages appear when the video signal is
not input correctly, even if the monitor functions
properly.
The massage might appear because some PCs
do not output the video signal immediately
after powering on. If the image is displayed
correctly after a short time, there is no problem
with the monitor.
Check that the PC is turned on.
Check that the signal cable is properly
connected to the PC or graphics board.
Use the graphics board's utility software to
change the frequency setting. (Refer to the
manual of the graphics board.)
Adjust the <Brightness> (The backlight of the
LCD monitor has a fixed life span. When the
screen becomes dark or begins to flicker, please
contact your dealer.)
Advertisement
Table of Contents
