Installation Procedure - Toto DSE101EEB Installation And Owner's Manual

INSTALLATION PROCEDURE - Spout
1.Remove nut, slip washer and bottom gasket.
2.Install the spout on the countertop.
3.Install bottom gasket, slip washer
and nut in that order.
4.Confirm the alignment of spout and
tighten nut.
INSTALLATION PROCEDURE - Controller
1.Select the position of the controller
and layout the mounting template.
Make sure the sensor cable and soap
tube can reach the mounting template.
2.Mark the location of the mounting
holes.
3.Drill 3 holes.
Depth : 1"(25mm)
Size: 7/64" (3mm) without wall plug
1/4" (7mm) with wall plug
Important: Mounting template to be level.
Remove
Slip washer
Nut
Tube
Countertop
Slip washer
Mounting template
5
Top gasket
Bottom gasket
Slip washer
Nut
Countertop
Bottom gasket
Sensor cable
Bottom gasket
Nut
Tube
Sensor cable