Table of Contents
Advertisement
INSTALLATION PROCEDURE - Battery Box
[DC Type]
1.Select position for the battery case.
Make sure the power supply cable is capable
of reaching the controller.
2.Mark the location of the mounting holes.
3.Drill 2 holes. Depth : 1"(25mm)
Size : 7/64" (3mm) without anchor
4.Insert a self-tapping screw into upper hole until
there is a 1/4"(6mm) gap between head of
screw and wall.
Use wall plugs if necessary.
5.Hang the battery case on the screw.
6.Insert a self-tapping screw through bottom hole
of case and tighten.
7.Connect power cord to controller.
1/4" (7mm) with anchor
Power cord
Self-tapping screw
9
1/4"
(6mm)
Advertisement
Table of Contents
