Yamaha EF2800i Service Manual page 55

1
a
1
SVU3470
GENERATOR
CAUTION:
Be sure to remove any oil or grease from
the tapered portion of the magneto rotor
using a cloth dampened with thinner.
NOTE:
When installing the magneto rotor, make sure
the woodruff key is properly seated in the key
way of the crankshaft.
3. Install:
• Stator coil assembly bolts 1
• Tubes
1
NOTE:
SVU3465 • Turn the magneto rotor until the stator coil
assembly bolts are visible though the holes
in the rotor, and then remove the bolts 1.
• Align the keyway a of the magneto rotor
with the stator coil assembly bolts 1 so that
they are in a straight line. The piston is at
top dead center when keyway and bolts are
in this position.
4. Tighten:
• Magneto rotor nut 1
• Washer
2
NOTE:
Tighten the magneto rotor nut 1 using the pri-
mary sheave holder 2.
3-27
ENG
Stator coil assembly bolts:
10 Nm (1.0 m · kg, 7.2 ft · lb)
Magneto rotor nut:
65 Nm (6.5 m · kg, 47 ft · lb)
Sheave holder:
YS-01880, 90890-01701