Dish Network DuoDVR ViP 722k User Manual page 88

Checking the Device Codes
Use these steps to find the device code you've set for each remote control mode (TV, DVD
.
or VCR, and AUX)
Instructions
1
Press and hold the mode button until
all the other mode buttons light up, and
then release the button. The mode
button flashes.
2
Press the POUND (#) button twice.
Watch the mode light to determine your
code. The mode button flashes the
number for each digit of the device
code, with a pause between the groups
of flashes. A quick flash is for zero.
For AUX mode: The first group of
flashes tells you what the AUX mode
controls. A quick flash (zero) before the
three-digit code is for a TV, one regular
flash is for a VCR, and two flashes is
for a tuner, or amplifier.
For a satellite receiver programmed in
AUX mode: The AUX mode button will
flash the same number of times as the
address number.
For Limited Mode: If you have
programmed a TV or VCR in Limited
Mode, the device mode button flashes
once at the end of the flash sequence.
Remote Controls
Controlling Other Components
Additional Information
For example, hold TV until all of the other mode
buttons light. When you let go, TV will flash.
For example, if the code is 570, the mode
button flashes five times, pauses, flashes
seven times, pauses, and flashes once quickly.
For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, and flashes once
quickly.
For example, if the receiver address is 3, the
AUX mode button flashes three times.
For example, if the TV code is 570, the AUX
mode button flashes once quickly (indicating 0
for TV), pauses, flashes five times, pauses,
flashes seven times, pauses, flashes once
quickly, and then flashes once (indicating it is in
Limited Mode).
79