Dish Network DuoDVR ViP 722k User Manual page 87

Chapter 10
Controlling Other Components
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page Codes First Left or if
you could not find a code that worked for your device, use this procedure to scan the
remote control's memory for the device code. In the instructions below, the column on the
left contains the instructions and the column on the right provides additional information.
1
Turn the device on.
2
Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The mode button
flashes.
3
AUX
For
VCR, or 2 for a tuner, or amplifier. Then
press the
4
POWER
Press
5
Press the
repeatedly until the device turns off.
6
POUND (#)
Press
7
Turn the device back on and try some other
buttons to make sure that they work also.
8
If necessary, repeat this procedure until
you've tried all the codes.
78
Instructions
mode only. Press 0 for TV, 1 for
STAR
(*) button.
.
UP DOWN ARROW
or
.
Additional Information
Use the device's front panel buttons or its remote
control.
TV
For example, hold the mode button until all of the
other mode buttons light. When you let go, TV will
flash.
This step is for programming the type of device that
AUX
will be programmed in
AUX
programming in mode, skip to step 4.
This puts your remote in the scan mode.
UP DOWN ARROW
As you press the or
remote tries each code in the memory to see if it can
turn off your device. When the device turns off, you
have found a code that might work.
Note: The mode button for the device will flash
rapidly eight times when you've scanned all the
codes for that device.
The mode button flashes three times if you have
entered the code correctly, and stores the code you
found.
POWER
Sometimes works when other buttons
don't. If using Limited Mode, also try
MUTE
.
You may need to repeat the scan to find the best
code for your device.
Note: This process could take a long time, because
of this remote's very large device-code database.
mode. If you're not
, the
VOLUME
or