Dish Network DuoDVR ViP 722k User Manual page 89

Chapter 10
Controlling Other Components
Setting Up by Learning from Another Remote
After you have programmed your DISH Network remote to control your devices (in TV,
DVD or AUX modes), you may find not all of the commands used by the devices' original
remote controls function as you expect. The learning function of your DISH Network
remote control can support these commands.
The remote control can learn commands in two ways:
1
You can follow the instructions for using device codes to program a specific mode, and
then learn commands that add new or overwrite existing functions of the remote control's
buttons in this mode. For this type of learning, any button without a learned command
keeps the previous command (if any) for that device code.
2
Each button on this remote learns a command from the equipment's original remote
control. For this type of learning, any button without a learned command will have no
function for that device.
To "teach" your DISH Network remote control specific commands for your devices,
complete the following:
1
Ensure the the desired remote address is
programmed to the DISH Network remote.
2
Place both your DISH Network remote and
the original equipment's remote control on
a flat, stable surface.
3
On the DISH Network remote, press and
hold the mode button for your equipment
for about three seconds until all the mode
buttons light up, and then release it.
80
Instructions Additional Information
See Checking the Remote Control Address on
page 73.
Holding either remote control in your hand may
cause learning to fail.
Your selected mode button will blink.