Point Dish And Check Switch - Dish Network DuoDVR ViP 722k User Manual

Point Dish and Check Switch

The Point Dish and Check Switch screens are helpful to the Customer Service
Representatives. You may be asked to display these screens when you call DISH
Network. Even though there are items that can be changed, only change them when
specifically directed by a Customer Service Representative.
Warning: Running the Check Switch test while the receiver has low or no signal
will result in incorrect receiver settings and cause you to lose channels. Do not run
a Check Switch test unless directed to by a Customer Service Representative or
other DISH Network instructions.
1
Press MENU.
2
Select System Setup.
3
Select Installation.
4
Select Point Dish. This screen shows you information to help maximize your satellite
signal. The bar at the bottom of the screen tells you the signal strength. Green is a good
signal, yellow is a marginal signal, and red indicates the signal is not acceptable or is from
the wrong satellite.
Connections and Setup
Using Troubleshooting Tools
123