Dish Network 118523 User Manual page 38

8. Connect
CH 21-69 O
using a coaxial cable.
: If you do not have an existing in-home cable system, you will need to
Note
run coaxial cable to each TV in other rooms. If this is too difficult, you may
want to contact a professional to do this installation.
9. Place the yellow sticker on the
attaches to the receiver. The stickers are located inside the front cover of
this guide.
10. Turn on the nearby TV (the TV that gets programming from the
outputs).
11. Make sure the receiver's green
12. Select the
Modulator Setup
With the
Modulator Setup
Control 1 to do the following:
a. Under
TV2 Out
(for cable channel numbers) based on what you wrote down in step 5.
b. Under
TV2 Out
modulator channel to the one you wrote in step 5.
c. Select .
Done
14. For some TVs, you must run a channel scan so that the TVs will find and
display the selected channel from the receiver. Run channel scan on all
remote TV(s), if available. See your TV user's guide for instructions.
15. Confirm that you see a picture from the receiver TV2 output on your remote
TV(s).
• If your picture looks good, go to step 23.
• If your TV(s) do not have a picture or if it is not as clear as you would
like it to be, go to the next step.
Connecting the Receiver to the TV(s) in Another Room(s)
on the receiver to your existing wall cable outlet
UT
CH 21-69 O
indicator is on.
TV1
(MENU 6-1-5).
screen displayed on the nearby TV, use Remote
, select either (for off-air channel numbers) or
Air
, use the UP and DOWN ARROWS to change the
cable near where the cable
UT
TV1
Cable
Page 33