Confirm Remote Control 1 Operation - Dish Network 118523 User Manual

Chapter 2
Receiver Description and Installation
Tip: In Dual Mode,
Remote Control 1
is used to control
TV1 menus on the
nearby TV. Remote
Control 2 is used to
control TV2 menus
on the remote
TV(s).
Page 30
RCA and S-Video Connections (TV1)
1. Connect one of the following video cables:
video cable (yellow) from the receiver
• RCA
TV's video input.
RCA
• cable from the receiver
S-V
IDEO
input.
V
IDEO
2. Connect the
RCA
outputs to the nearby TV's audio inputs. If the TV has only one input for
this type of audio, connect it to the right (R) phono (RCA) audio output on
the receiver.
3. Make sure your nearby TV is on and set to receive TV from the correct
audio and video inputs. Refer to the instructions that came with your TV.
4. Plug in the power cord for the receiver.
5. Turn on the receiver with the front panel power button and make sure the
green TV1 indicator is lit.
6. You should see the

Confirm Remote Control 1 Operation

After the nearby TV has been connected to a
methods above, do the following to confirm that the IR Remote Control 1
controls the receiver:
1. Make sure that fresh batteries are installed properly in the IR Remote
Control 1.
2. Press the SAT button to put the IR Remote Control 1 in SAT mode to
control the satellite receiver.
3. Use the Remote Control 1 arrow keys to move around the
screen. If you are able to move around in the
confirmed that Remote Control 1 is controlling the receiver.
outputs to the nearby TV's
TV1
audio cables (red and white) from the receiver
screen.
Point Dish
TV1
outputs to the nearby
TV1
S-
TV1
output using one of the
Point Dish
screen, you
Point Dish