Table of Contents
Advertisement
Scanning Scenarios
Using ScanWizard DI
ScanWizard DI is a scanning software designed by Microtek for document
scanning in color, black and white, and grayscale in both duplex and simplex
modes. Its user-friendly interface enables you to easily start the scanning
process. Refer to the ScanWizard DI software manual for more details.
The following sections will show you step by step how to use ScanWizard DI.
Scanning Documents
1. Place the document to be scanned either on the scanner's glass surface or
2. Launch ScanWizard DI as a stand-alone program by clicking on the
3. Click the Scan Setup button in the interface to activate the Scan Setup
4. In the Scan Setup interface, follow the steps below to specify your basic
18
ArtixScan DI 2015c User's Manual
Warning:
•
Do not place photos or fragile materials in the feed tray, for it will
damage the originals when performing the feeding process. Always place
frail originals on the scanner's glass surface and choose "Flatbed" as your
Scan Source.
•
Before scanning the document from the ADF, make sure the flatbed
scanning area is clear from any obstructions. Otherwise, a scanning error
may occur.
into the scanner's document feed tray.
ScanWizard DI icon on the desktop.
interface.
settings.
a)
Select Flatbed or ADF (Simplex) in the
Scan Source as your image input device.
b)
Select the appropriate image type in the
Color Mode as your image output type.
–
Select RGB Color (24 bits) to scan
the image in color.
–
Select Grayscale (8 bits) to scan the
image in grayscale.
–
Select Black & White (1 bit) to scan
the image in black-and-white.
Advertisement
Table of Contents
