Table of Contents
Advertisement
Additional Recording Features
Erasing a CD–RW Disc
Although more expensive than
are two basic erase options available: erase the last recorded track; and erase all tracks on a disc. If you haven't yet finalized
a disc, you can choose either option. Once finalized, your only option is to erase all of the tracks on a disc.
A third, special option, erases (re-initializes) the whole disc. This process takes quite a long time to complete and should be
used for recovering damaged discs, not for erasing tracks from a healthy disc.
CAUTION!
Never switch off the power during
do accidently disconnect the power during the track or disc, the recorder will try and re-initialize the disc once power
is restored. Unfortunately, it may not be possible to complete the process successfully, and the disc may be dam-
aged as a result. You can halt this (and any other) erase process by holding down the 7 (stop) button for 10 seconds
while the recorder is trying to recover the disc. The display shows the message
has not been successfully erased.
If the message
the erase command again.
Be sure to remove the disc from the recorder before switching off the power, otherwise the erase operation will not
be completed.
Digital Recording System
Function indicator lights
in orange when erasing
3
34
<PRB1286>
–
discs, the great advantage of
CD
R
–
CD
RW
appears any time during any erase process, hit eject, take out the disc, clean it, then try
CHECK DISC
2
Erasing the last recorded track
1
◊ÛB - ,/Bˆ
2
3
Hi-bit Legato Link Conversion
–
is that the discs can be erased and reused. There
CD
RW
erasing - your disc may become unusable. If there's a power failure or you
Load a CD–RW which has not yet been finalized.
Press ERASE.
The recorder prompts you to confirm with the message
?, and the recorder function indicator blinks
LAST TRACK ERASE
orange to indicate erase standby mode.
Press 7 (stop) to cancel last track erase here.
❖
❖
If you don't proceed to step 3 within eight seconds, last track erase
is cancelled.
Press 8 (pause) to start erasing.
The process takes just a few seconds. During this time, the function
indicator lights orange and the display shows the track number being
erased.
to indicate that the disc
CHECK DISC
Advertisement
Table of Contents
